CMI BASE COAT PLASTER 381 & 781

ADVANTAGES

  • Consistent Quality
  • Minimizes Cracks
  • User Friendly
  • Water Resistant
  • Enhanced Workability
  • Cost Effective
  • Optimum Bond Strength
  • Cleaner Worksite

PRODUCT

CMI BASE-COAT is a high quality polymer modified water-resistant cement-based thin plaster for concrete walls or ceilings. It is also good for surface improvement works to block wall and concrete wall surfaces.
CMI BASE-COAT should not be used on painted surfaces.
CMI BASE-COAT is available in 2 (two ) colour :
a) BASE MORTAR WHITE 381
b) BASE MORTAR GREY 781

TECHNICAL DATA

CoIour/ Binder : White/ Grey Cement.
Filler : Limestone/ Graded silica sand.
Additives : Water soluble polymers to improve workability, water-retention and adhesion.
PH. : 12.
Aggregate size : 1.0 mm max.
Potlife : 2 hours.
Coverage : Approximately 1.3 kg/ m2 / mm thick.
Recommended thickness : 2 – 3 mm per coat.
Density : Dry 1 1.3 kg / litre ;Wet 1 1.7 kg/ litre.
Toxicity : Chemically inert and non-toxic.
Mixing ratio : Approx. 30% on dry material.
Packing : 25 kg & 40 kg.

APPLICATION PROCEDURE

Receiving surface for plastering must be sound and free from dirt, dust, grease and traces of foreign materials that will affect adhesion. Where necessary, dampen the dry concrete or rendered surfaces before application of CMI BASE-COAT. Add a 25kg bag of CMI BASE-COAT to approximately 7.5 liters of clean water. Use a power drill to mix thoroughly. Allow mixture to stand for 10 minutes for additives to dissolve. Before using the plaster, mix again. Apply by using a steel trowel or spatula.

STORAGE

Storage life is approximately 6 months if stored in a cool and dry place.

Note : Because it is not possible to give specific instruction for the various site conditions or to control the applications, the information here is for general guidance only and does not constitute an offer of warranty by the manufacturer

Next Product:

Previous Product: